girando in rete ho trovato queste specifiche spero che possono togliervi qualche dubbio
introduction
the element univer sal weapon
flashlight system em961xm07 attaches
to picatinny rail interface-equipped
shoulder-fired weapons via an included
dual thumb screw mount.
kit contents:
•
• xm07 weaponlight tape switch
•• em961xm07 body assembly
•
• thumbscrew mount
•• user manual
installation
1
11 install the battery into the body
assembly with the (+) positive
terminal facing forward.
2
22 h o l d t h e em9 6 1 xm0 7 b o d y
assembly against the rails on the
weapon and tighten the two thumb
nuts on the m49 mount or hold the
em961xm07 body assembly against
the rails on the weapon and rotate
the lever on the m50 to lock the
unit onto the rails.
3
33 tighten the rear cap finger tight.
the tactical light is ready for use.
4
44 apply pressure to push button
switch to activate light. light will
stay on as long as pressure is
applied. turn the tailcap clockwise
until snug and the light will activate.
deactivate light by unscrewing the
rear cap assembly one full turn.
this will prevent unintentional
activation.
warning: confirm that weapon
is unloaded and on safe before
user manual
em961 & xm07
universal weaponlight
max output 188 lumens
minutes
runtime
45
switch
assembly
um or xm
bezel
diameter
1.62 inches
mount
thumbscrew
batteries three 3v lithium cr123a batteries
features
lamp replacement
1
11 unscrew bezel from lamp housing.
lift lamp/reflector assembly out of
bezel.
2
22 insert the replacement lamp/
reflector assembly into the bezel
and reassemble by screwing the
bezel onto lamp hosing until it is
fully seated.
battery installation/
replacement
never mix new with used batteries.
1
11 unscrew the rear cap and slide out
old batteries.
2
22 install new battery with + terminal
facing bezel.
3
33 reinstall rear cap.
warning: l i t hium b a t t e r i e s
can explode or cause burns i f
disassembled, shorted, recharged,
e xp os e d to wate r, f ir e, or high
temperatures. do not place loose
batteries in a pocket, purse, or other
container containing metal objects,
mix with use d or other bat ter y
types, or store with hazardous or
combustible mater ials. stor e in
cool, dry, ventilated area. follow
applicable laws and regulations for
transport and disposal.
caution
the battery used in the light is very
powerful. be sure that the switch is
not touching anything when the light is
stored. if the lamp is turned on while
in a case or other container, the lamp
can overheat and damage the light or
surrounding materials. remove the
battery or unscrew tailcap far enough
to prevent the lamp form turning on
when stored.
use care when replacing lamps. use
only lamps specified in this manual.
if it is necessary to dispose of any
bat ter ies , do not do so by f i re,
mutilation or disassembly, as this may
cause toxic chemicals to be released
Portale
Lo staff
In attesa della conferma e-mail
Originariamente inviata da truzzoweb
